Keyboard shortcuts esc
Jump to a page, run a command
⌘K
This list
?
On a course
Next / previous article
↓↑
Mark it learning, then mastered, then clear
mspace
Open it
↵
Edit it
e
Switch version
s
Hide it from your progress (undo under Course & progress)
h
On an article
Previous / next article
←→
Mark learning, then mastered, then clear
m
Edit the article
e
    ↑↓ navigate ↵ open ⇥ only that course esc close

    Heelside Sliding & Stopping

    Edit · suggested by renec112 · Oct 11, 2026

    Article title and content updated

    Added This suggestion was approved on Oct 11, 2026 - the changes below are live. View live article

    Final community vote: 0 yes / 0 no

    added removed

    Sliding & Stopping Heelside Sliding & Stopping

    renec112

    fundamentals turns

    New header
    New image
    Removed image
    Skill:
    slide and stop on a snowboard

    Your very first time on a snowboard with both feet strapped in and actually moving. Figure out whether you are regular (left foot forward) or goofy (right foot forward), then stick with that lead foot for now so you build one consistent habit. Strap in on the flattest beginner slope, pointPoint the board straight downhill,downhill ride a little, and slide with your knees soft and weight centered. To stop, turn the board perpendicular to the slope and press into your heel edge. That's a heel-side skid stop. PracticeNext article will get you to practice toe-side stops too: same perpendicular finish, but press into your toe edge so you can stop confidently on both edges.

    Here is a video explaining how to slide and stop:

    YouTube video YouTube video

    Video by SnowboardProCamp

    Remember to practice both heelside as depicted in the header of this article, and toe side stops:

    Source: SnowboardProCamp

    Key tips

    • Keep your knees bent and back straight
    • Look where you want to go, not down at the board
    • Start on the flattest green slope available
    • Practice heel-side and toe-side skid stops until they feel automatic

    Discussion (0)

    No comments yet.

    Log in to leave a comment.