Keyboard shortcuts esc
Jump to a page, run a command
⌘K
This list
?
On a course
Next / previous article
↓↑
Mark it learning, then mastered, then clear
mspace
Open it
↵
Edit it
e
Switch version or status
s
Hide it from your progress (undo under Course & progress)
h
On an article
Previous / next article
←→
Mark learning, then mastered, then clear
m
Edit the article
e
    ↑↓ navigate ↵ open ⇥ only that course esc close

    No Comply Shove-it

    Edit · suggested by renec112 · Sep 30, 2026 19:38

    Article expanded and image added

    Added This suggestion was approved on Sep 30, 2026 - the changes below are live. View live article

    Final community vote: 0 yes / 0 no

    added removed
    Header image

    No comply No Comply Shove-it

    Skill:
    do a no comply shove-it on flatground with style
    Prerequisites:
    Shove-it

    The no comply shove-it is a super stylish flatground trick where you step off your board with your front foot, spin the board 180 degrees with your back foot, and jump back on.

    How to do it

    1. Drill the scoop standing still. Front foot on the ground, back foot scoops the board through a backside 180. Repeat until it lands flat and predictable.
    2. Jump onto it. Same scoop, but leave the ground before the board lands and aim to land on it. Low risk if it goes wrong - try it walking into a bank.
    3. Add the step-off. Stand on the board with your back foot on the bolts, not the tail. Jump off with your front foot and scoop with the back foot the moment your front foot touches the ground. The two have to be synced.
    4. Do it rolling. Slow at first. Back foot on the bolts, step off, scoop, jump on.

    Common mistakes

    • Back foot on the tail. The board shoots away when you step off. Keep it on the bolts so the board stays put.
    • Scooping late. If the scoop comes after your front foot has landed, the trick looks disjointed and you step on one foot at a time. Time the scoop with the front foot touching down

    Watch more here:

    Source: Man Vs Board

    Discussion (0)

    No comments yet. Be the first!

    Log in to leave a comment.